- Spider gears FUBAR'd
- LQ9 or LS2 coil packs on a 5.3L ???
- 04 escalade??
- Emergency Brake
- Decoding Cowl Tag on 1990 454 SS
- Best way to drop my truck 2 -2
- what do do next?
- Denali exhaust
- fuel pres. reg.
- How is this for a 5.3 cam
- injectors
- No overdrive
- Loudest exhaust for 5.3
- Any good exhaust shops in San Antonio?
- tcs stalls?
- Which Heads should I Use
- 4l80e? Or 4l60e?
- stock 4L80E at 425rwhp ?
- Transgo HD-2 Install writeup
- Headers
- cam selection
- port and polish 862's?
- p0102
- Engine Knock started 282,375 miles
- Servo removal and install videos
- Servo Pin
- Cruise Control?
- OBX headers and exhaust
- Vortec Max?
- engine decisions
- Lift it, Slam it, or bag it?
- steering shaft
- Which tranny do i have?
- Dealer Service Book
- no brake lights yet 3rd brake light works?
- New Converter And Shift Kit Pic Thread
- 08-501-8 comp cam?
- GM hot cam or any cam recomendations
- Help with rods and crank.
- Need Help???????
- Vibration after 2 inch rear drop? Help?
- The Science of Slicks
- at what hp would a inline fuel pump come into play or be needed?
- FLT 4L60E GOES 9.25 @ 146 IN JR's C5 TODAY!
- Plans for truck (Advice needed)
- Picking the right cam?
- ticking noise when first started
- Cam And Converter Choices
- oh no
- Motor Swap 11/8-11/9
- Stock locks/ retainers with yellow springs?
- big problem with spark plug!!!
- Size of Tubing and Heim joints for Traction Bars??
- Would new cam be worth it?
- Changing spark plugs
- another of my "which one" threads. water pump
- Junkyard rear axle swap ?
- Rear differential
- 6.0 cam in a 4.8?
- Engine losing oil
- Cam,converter,tune Question
- LS2 Block
- Will i notice a difference? 3.42's to 4.10's
- Oil Level Low!!! Help
- Gutting the Cats
- i small fuel but it is not leaking
- ok so im really confused
- Another Spark Plug Question
- nelson harness
- 4L60E converted to non electronic
- San Antonio guys...recommendations on shops?
- insurance money = cam money for VHO
- Ducky Dont Freak.@@
- pcv bypass filters?
- Finish Line Transmissions (FLT) Winter Holiday Sale With New Policies
- Gas guage twiching!
- Need help...2/4 drop question
- Cam question
- When good underdrive pulleys go bad...
- Vic Jr. intake ?
- Which rout to take.
- what kind of
- Ruined cam - how?
- TC and towing?
- What do you think of this cam??
- A little touch of milky oil
- Shorty header install
- F.A.I. idea...worth it??
- 180 t-stat
- stall break in!!
- throttle body
- removing clutch fan?
- removing clutch fan?
- 5.3 active fuel management swap
- Dipstick removal ???
- 4.3 blazer stalling out on me
- Need some info
- plug wires
- PI vigilanti installed !!!!
- Humming noise while driving
- 93 gmc 3/4 van 5.7 tbi cold start problem
- Long Tubes on a 4x4
- how to check for coil bind
- where to buy a stall
- Loud rattling coming from underside of truck!
- cam and thermostat question
- Bad LS Engines
- Humming Sound In Front-End
- More Stall out of the stock converter
- Coolant Problem
- Upgrade injectors?
- Hughes Convertors
- FI Cam on NA Engine
- 5.3/6.0 cam
- L92 heads on 6.0
- What Route is the Cheapest way to go?
- 2" Front Leveling Kit
- Decided on my 5.3cam tell me what you guys think
- Anyone ever used or seen this valve spring tool?
- Codes...
- Trans
- Anyone here with DJM 4/6 Drop on a RCSB OBS?
- New Tranny?
- Gears
- Akansas Tuning
- cam for a turbo motor?
- 2007 brake rotors
- Broken dipstick tube.
- My first mod!
- Brakes
- year, engine, mileage, and how hard?
- Please help me! All kinds of problems!
- 4.8 p.s. delete pulley?
- Installed The Cam
- Heads question
- Forum for 98 body style trucks for Mechanical and Mods
- So here is the plan.
- T56 & 5.3l
- driveline question
- arp head bolts?
- Maf
- Header bolt size
- Servos
- What do you guys think?
- Knock Sensor Problem???
- Air intake question about a brand
- My Schoenfeld Headers Install
- Got my transmission back
- 06 5.3 cam question
- 5.6 for ls6 swap????
- vortec for ls6??
- 98 Chevy heater controls location.
- Traction Bars
- Just to be sure
- L92 truck intake
- TurboMics truck getting new suspension
- Suggestions of Mods.
- Suspension/Drop Questions
- Need some Part #s
- Bassani ML headers.
- Couple questions on 6.0 and 4l80e
- Trouble with E-Fans
- Nelson Tune
- Hey you turkey's.......message from FLT
- 5.3 ls1?
- New exhaust
- Am I asking for trouble
- Running rich
- Transmission Shift Problems
- trouble!!!!!!!!
- Cam ???
- headers
- 3" exhaust
- broken shift cable
- Oil pressure problem
- next mod
- Lost 3-4 clutch pack...exploring options...
- What are some good rear shocks?
- 65e?
- which radiator
- 5.3 Vortec?
- 1.8 Rockers on 243's with stock cam 4.8L
- Muffler options
- Need some transmission help
- 96 4l80???...
- Transgo HD2 shift kit
- LS1 Swap part Help me find one please?
- electric fan question
- ProForm rockers
- Help Diagnose a Problem
- Help!!! Did I wreck a head because of one bolt?
- runs very bad when cold
- Lingenfelter heads
- s10 to handle
- Converter On the Fritz??
- Truck went into reduced engine power
- 1BrokeC10... Motor Knock
- 3000k Yank stall in
- !!!help!!!!
- Servo assembly...
- Transmission Help!
- Filling cooling system?
- Heads up....
- Heater Core?
- Almost a no start.
- does a 4l80e take more power to turn than a 60e?
- Fuel cut Before shift?
- Head Cam Combo
- Rear End Swap
- drag shocks
- Codes
- motor mounts
- 6.0 best cam/head 4 torque?
- Brakes help
- 2008 Tahoe 5.3L at 320hp
- Update and good advise
- Radiator hoses?
- TBSS intake on '02 Tahoe questions
- yo!! HIC = Bryan!! spill the beans
- 5.7
- Transmission... what to do??
- Transmission Wining..
- Compression Check ?'s
- W/b 02 Bunge
- t5 onto lq9
- Flex plate for 5.3 on a 2001 truck
- ? About Exh. Band Clamps
- 2008 1/2 ton -> 60e to 80e swap, How?
- Rear End tear down
- I think I am having tranny issues
- 4.8 Question
- Water Pump Leak
- For you differential guys:
- 4L80e rebuild
- Clank when starting and stopping
- 95+ brake switch won't close
- Oil pump I think
- Rear end fun
- How much lift untill reliefs are necessary?
- 5.3 to 6.0 cam
- Transmission R&R in 4wd Tips needed.
- ... My Automatic is a Manual
- Alittle whine from new gears?
- What to do about slipping trans?
- stock dyno sheets?
- Oil drain valve
- 5.7 gto cam in a 5.3
- servos?
- Trans slippage?
- How to do a cam swap