- Lifter Dropped..... HELP please
- Stock reg 1:1?
- FINALLY think my 4L60 is DUN
- Transmission in DD
- Twin pumps
- Knock Sensor issue
- 4l60e ?
- cant find my lifter
- Fuel rails/regulators/etc
- Mobil 1 0w-30?
- Shorty Fuel injector spacer / cup
- lifter alignment
- what kind
- ? on pump for 4l60e
- 4l80e is there a year to get
- oil cooler??
- Air Fuel Ratio
- MAG-HYTEC oil pan , 4L80E
- transmision oil
- 15" wheel on a 14 bolt
- re-gear before tune?
- swapping gears
- ls3 or l92
- coolant crossover
- Trans cooler help
- evap solenoid on intake manifold?
- driveshaft problem
- built me a set of traction bars
- ANOTHER problem with my 4l60E!!! no Overdrive!!
- Ls 383?
- Possible drivetrain problem?
- What Years Rims Can I fit On My 06
- How big?
- Normal trans temp operating range?
- What heads are good for 5.3L build. Ive looked and cant find info
- Cam Advise
- Tru cool 40k trans cooler
- Good deal or no?
- 6.0l needs rebuild suggestions for mpg
- Can I pull my front axle on my 2 door yukon?
- 5.3 to 6.0 or 5.3 to 6.2?
- crinkle bend vs mandrel bend exhaust
- problems with the 1.8's
- 1.8 problems continued...engine failure
- Tune Up
- LY6 into a 2000 silverado what needs to be done to get cvvt to work
- 1993 Diesel 4L80E behind a 2002 4.8?
- Rear diff after a few mods
- indexing plugs?
- another TB converter question (new flex plate??)
- 4.8 throttle problem
- Synthetic Oil
- Guys with built d-shafts, come in please
- fuel line quick disconnect - male end
- Cork trans pan gasket
- 2002 4.8 with 1999 F Body 4L60E
- NNBS fuel system...
- need help
- T-56 GM/Ford application differences
- Transmission cooler Question
- Having to pull the motor! sucks....
- Edelbrock 3869 90mm throttle body gasket
- help
- EGR delete
- Oil pressure sending unit
- Borla?
- 4L80E swap... starts in 2nd and won't downshift or respond.
- Help
- 4L60E Shifts REALLY hard...
- ALL transmission codes on??? need help
- Transmission electrical problem..need help!!
- A new Circle D billet piece... and a fluid experiment... interesting results...
- electric water pump drive
- wear feeling when going 80+
- Gear installation write up?
- Oil Consumption???
- Need to know what transfer case I would have.
- 6L80E Jake Brake
- just bought a 6.0
- Trans thread part 2
- 4.10 install kit?
- Z06 Brakes
- HELP!! Shifter linkage on 4l60e
- Need help with blown 408
- Idle too high
- HELP! I hate torque converters!
- Hoping I wouldn't have to do this
- A ? for all u 4l80e guys
- MSD wire question
- trans cooler help needed
- will these 4.10 gears fit my 2002 silverado
- Injector on a 2006 colorado
- 4l60e from S-10 into my OBS???
- NBS FPR, Where is the damn thing?
- 160 Stat
- Lifter
- TCI fun?
- True-trac and gears
- searched but unclear on tranny cooler install. need help.
- Steering quickner
- 4.8 wont start on first turn
- Torque Converter Lockup
- Pretty sure im blew my 4l60e
- What kind of stall to get?
- 01 water pump on a 05...
- Still having a werid problem with my truck
- 4 link question..
- 5.3 cam retainer
- 4-link vs. 3-link
- corvette servo install problems
- Steering shaft
- LS6 Valley Cover PCV
- 9.25 front axle stuck?
- Engine rebuild 2001 4.6 LU3 / upgrades - Advice
- those with hydroboost conversion come on in
- Twist Tite fittings and hose?
- Throttle cable questions
- Brake question
- ordered 408
- Overlap?
- whats the best spark plugs??? and whats the best performance mods for $900???
- i have 23psi fuel pressure....help
- PerformaBuilt Trans . and stall ?'s
- trans swap = fail on 1/4 times. ideas?
- nasty hesitation on part throttlle shift, any answers why?
- clanking noise explained
- Lost 3rd and 4th Gear after hitting the floor with my size 12
- Want to swap my NNBS for a SS. Can I swap my supercharger out and put it on the ss?
- Broken axle
- Anybody know what parts i need to convert a 4wd 4l80e into a 2wd 4l80e?
- Assembling AN fittings?
- Awd
- need help with 5.3 direction
- Dual exhaust ?
- need help with rear end
- TH350 or TH400?
- what gears to buy and maybe a locker???
- No forward or reverse gears help!
- 2K Stall need a tune??
- HELP! rebuilt my 4l60e, now it doesnt move.
- catch can to breather tank
- 4L80e swap on a 2007+ 4wd 60E
- 1st to 2nd hits hard
- Accessory setups that can fit a 4.8L to clear a LS1/LS3 Intake?
- Help trans probs need input asap
- need a little info please
- Turbo 4x4 1500 launches violently
- trans ?
- What stall for my cam?
- NNBS 4l70-e to 480-e swap.
- My 408 or 414 build?
- tie rods
- boost controller
- 4L80 year question
- is this the right rear end kit i need
- is this the right trutrac i need
- 4.8 to 5.3 ?
- 160 stat for 09 GMC?
- 14bolt sf swap possible?
- Got a package from Chris at Circle D
- 216/220 or 222/224 cam
- Filler neck question
- rear axle leaking
- Spark plug wires
- Denali gauge cluster
- 4 x 4 cam
- aluminum 5.3 block???
- AWD to 4x4 conversion
- Longtube install
- Dynamic CR and Static CR
- Fuel Cell Advice
- Fully committed now..
- LS7 cam in5.3 plausable or not
- What is this? What does it do?
- The new Bullet!!!
- New Engine Running Bad Please Help!
- 4th gear servo
- Need help with valve seals
- Flapping? noise coming from intake
- 4l80E housing difference
- 4L60e to 4L80e
- questions on bottom end
- Lifter noise
- need help
- oil smell
- Front wheel seal help
- 4.8 or 5.3 w/ manual trans in 2WD 1500?
- 8.5/8.6 Question
- Header Primary Size
- Questions about buying a Shortblock
- MLP and PRNDL switch
- new motor
- Where to find new motor? My took a crap.:(
- Stay away from texas performance transmissions! Fraud,false advertisment!
- Returnless vs Return Fuel System
- Comp 918 failure caused #6 piston to disenegrate :(
- I'll try
- Cool Idea
- sts scavenge pump bites the dust
- Oil Level Sensor
- 4l60E acumulator and Check ball question????
- coolant
- 5.3 vs 6.0L in gas mileage question
- 6.0 Heads for sale. Is this a good deal? $190
- would this cam fit a 5.3?
- 2004 silverdo 2500 HD question about fuel rails and steering column
- Knock Knock, Who's there? Steering Shaft
- blew trans have questions for replacement!!
- FLT users...
- motor oil
- TQ Lockup
- Best place to get head gaskets?
- Converter may be slipping
- hard cold starting
- So this is probably a dumb question...
- 4l80e swap question yoke driveshaft
- 2000 4.3 swap to 96 4.3 same engine?
- Is a 2003 4L60E the same as a 2009 4L60E
- What are you guys doing ?
- 5.3L LM7 and T-5? Parts questions!
- Head bolt sequence and torque specs?
- Will i need to upgrade my fuel injectors?
- reduced engine power
- Buyin a Denali.. 6 speed trans?
- 4l80e 1st gear
- What some may not know about Finishline Trans
- 4l80e ??
- What Fuel Pump To Use For My C1500 LT1 Swap
- Transmission too cold? Is that even possible?
- Head bolt torque specs?
- EXTREME4x4 on powerblocktv.com
- returnless to return style fuel system
- Truck seems to like 1st gear too much
- 5.3 Rebuild kits people on here have used? and Build sugestions
- LS1 with 862 heads
- What is the pipe running from head to head
- 4L80E not engaging reverse.
- What is the diameter of the LS1 fans (the blades)?
- belt length
- vette servo ?
- cam question
- 2000 6.0 engine swap
- 15's up front?
- Goodbye from Vince @ FLT
- 4l60 wont go into over drive... help
- LQ4 and LQ9 CR's
- Torque Conveter locckup
- 4L60E's Proper Fluid Level, How Can I Determine If It's Correct?
- Speedometer problem after converting to 4l80e
- 2wd Output shaft for my 60e