Forum: Strip

went 9.06 with me(305lbs) and my gf (105) in the truck on street tires. I've did a little weigh reduction. truck is a RCSB 05 5.3 with 4:11 gear,...

Ok I have a 224/228 581/588 cam, 3600 verter, LPP headers, 4.10's tru trac, 26 inch slicks hookin out of the hole on a 150 shot and my best E.T. is...

Well guys took The LSX to the track friday got a 7.9 at the 1/8 and a 13.3 at the 1/4 let of at the 1/8 cuz of no cage motor is a LSX 454 7.4L...

Who was driving the silver rcsb with the dented hood tonight? 7.28, dayum! :thumb:

The little LQ9 that could is not just a Dyno Queen... Went 10.57 @ 127 (fastest pass) tonight at Temple of all places lol... spinning 1.8-1.9 60fts...

Took the truck out there with slightly less gas than last time LOL. Made quite an improvement, still slow as shit though. Last times best: 16.25...

When we went to the track last weekend which is a 1000' track, I let my buddy run my truck and his dad went alon for the ride. They lined up to a...

Badass 10.5 tire racing this weekend! Be there!

So im bringing the truck and my roommate is bring his z28 to centerville this weekend. This is the first time running it since i put the traction...

I have an 07 RCSB with a 5.3 in it, and I'm thinking about running it out at "the strip" out in las vegas......it would be the first time that I've...

What kind of set-ups do you guys run when you are at the strip? I am looking into getting a set of D/Rs for the rear of my truck. I am wondering...

Went to savannah river dragway saturday hopin to get some good runs in, well it was still pretty hot, and still had some wheel spin off the hit, but...

Lol I knew it was slow, but I didnt think it would be as slow as it is. I had a few things against me (Full tank of gas, 275/60/20's rolling, system,...

6.2/60e Circle D 3200/vette servos Pacesetter LT/OR-y/14" magnaflow Milled heads (.020") 228/236 112+2 cam 4" CAI UD Crank pulley 90mm TB...

well finally managed to make a couple of passes after 8 months of the build, truck is a 91 rcsb 6.0 lq9 full bolt on, tbss intake, 90mm tb, built...

Finally got the truck to the track. I can't shift this god damned tranny to save my life. My old '90 with a Hurst shifter on the 5 speed was pretty...

06 Silverado RCSB 4.8, 3.73 gears, Pacesetter long tubes with full true dual exhaust through Magnaflow race mufflers, Cam Motion 221/226 .550/.575...

took the truck out once again: The Night wasnt all that bad temps were 77* DA was +800+ truck was running very well, first off wanna thank Quik for...

does anybody knw wat kinda times i should be seeing wit an LQ4 wit and without tune?? my engine should be ready by thursday but i just wanna knw some...

I ran a 13.99 and a 14.02. My truck needs the tune checked out but overall I am very pleased to see that it went into the 13's. My 60 foot times...