Forum: LSX Truck Conversions

I'm getting down to the final stage of my swap, I have my harness thined out and lengthened/ shortened. So this leads my to the fuse block and...

I have a LQ4 from a 2003 2500 Sierra. I got this motor without any accessories. My friend and fellow LSx engine enthusiast called me the other day...

I’ve been jumping between different gaming platforms lately, trying to figure out why some online casinos feel smooth, fair, and genuinely exciting...

So, I just want to put this out there before anyone else gets screwed over by this *******. Johns custom wiring 475 E South Airport Rd Traverse...

I have a 94 2wd with the early 4l60E, and i plan on doing a 5.3 swap and sticking with EFI.Id like to run either a stock truck harness or a Nelson...

ive got a 98 f-body ls1 with a street and performance wiring harness. Just wondering if I can even start the engine without having the computer...

Well, I was gettin in to the nitty gritty of things today and ran into a problem. I removed the bed and about 6 inches back from the cab, the frame...

91 silverado, 2001 5.3, 95 dash.(no airbag in it, has cupholders) I took the underhood junction box from the 2001 and have it on my fenderwell....

I am trying to find the cheapest but easiest route to my power goals. I can buy a used cheap 5.3 with high miles and swap the shortblock out with a...

I know I've talked a little to Ron on this board about his M5 to M6 swap, but has anyone swapped an A4-M6 in the NBS trucks? My main questions are:...

alright, Ive done alot of searching and found a lot of good info but not quite what i was looking for. I found a 6.0,4l80e,t-case, wiring...

If I go with a computer from an LS1 for my 5.3, can I use one that was for a 6 speed car and have it programmed? As of now, the only computer I have...

Hey folks! I've been exploring online casinos for a while now but still feel like I’m not getting the most out of my experience. How do you maximize...

On the 5.3 starter there are 3 posts on the starter. With engine in truck. The biggest post closest to frame goes to battery hot. The small post...

Couple of questions? 1) the vapor purge valve on front of intake can we get rid of this or is it something needed? If I do keep it does it tie in...

I'm new here and i'm doin a conversion useing a 2003 5.3 and 4l60e . My question is now that i have removed the un needed wires from the harness i...

I am swapping a 4.3 in a 2006 silverado 1500, to a 6.0 LQ4 from a 2002 2500 I have engine, fuse box, pcm, and harness from the 2500, am I better to...

I'm going to post what I did to mate my nv3500 to my 5.3 since I wasn't able to find any reliable info when I did my swap. I bought the flywheel from...

Hello all, I completed an 8.1L swap last year in a 70’s GM truck using a MEFI-4 ECM. Never got that damn thing tuned right so I just replaced ...