need the spring anchor plates (mount on bottom side of axle tube) and the spacers (mount between ubolts and top of leafs) to fit 3/4 ton 14 bolt SF w/6 lug..............cant use the rusty brand...already got those models.......thanks
WTB 3/4 ton/14 bolt SF spring anchor plates and top u bolt spacers
need the spring anchor plates (mount on bottom side of axle tube) and the spacers (mount between ubolts and top of leafs) to fit 3/4 ton 14 bolt SF w/6 lug..............cant use the rusty brand...already got those models.......thanks
'93 Chevy Sport... LS2...T56 Magnum..."Red Rider" under construction.........
I used the 1/2 plates when I went 14 bolt, had to grind the radius out a little bit but they worked fine even with me hitting a 300 shot on them.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
how was the center to center spacing on the plates for use on the bigger tube....or you must have used the 1/2 ton ubolts??Originally Posted by RedHeartbeat
it was off a little bit. I really had no choice but to use the 1/2 plates since they had my caltrac mounts welded to them. Most people recommend to get new ubolts any time you take them loose since they rust and pit, plus they get bent and stretched as you torque them down.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
how much did the caltracs help with hop, traction etc.? and did they cause you to lose any steetability or handling?? I see another company makes the Assasin bars....lots of adjustability in them but do you really need that much?
I didn't need the bars to stop wheel hop, only to help on my launch. I dropped about .2 on my 60ft times with them. I haven't tried the Assassin bars but I wouldn't blink an eye to go fo them, they look slick.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Anybody got these parts kickin around??
you can get them from 4 wheel parts
Hand p&p heads, 219-227 .607 .613, pacesetter, tbss intake, 92mm t-body, cai, e-fans, 14 bolt, 4.56, true trac, pi 2800, 33's, 4l80e built by me
In the makin
Boost.
I need the stock OEM plates.........these guys sell aftermarket stuff....thanks anyway..............
????
Posting Permissions
Reply With Quote