HMP 1/8 results yesterday 7.28.08

[-HIC-]

Nice times man! Not too shabby for it being so hot lately. Any word on the heads? I am getting real antsy. I am kinda using you as a guinea pig for the results--cause I am either gunna do the heads, bigger cam, and larger stall--or just go with a 112 Radix.

man I have actually been thinking about buying a 6.0 then having my 5.3 heads worked and put them on the 6.0 with a bigger cam and 3500 stall. just b/c I can get a 6.0 for just 400 more than those prc heads.. Ill let ya know, probably wont do much until it cools down.. If I can keep shaving my 1/8 mile time I may just spray it and call it good.

[-HIC-]

nice times hic, I went to hrp friday night full weight with 20's and went 8.28 to give you a comparison.

had the slicks on the back for traction and pulled 1.81 60' times. 1/8 mile mph was 84 top speed was 102.?? in the 1/4

What size are your slicks? I ran my 28's no wheel spin at all and I cant get below 2.0x what gives? My setup has to be capable of pulling some better 60's I am not sure what to do.

When will you be going back to HRP? Would you mind if I roll with you to see if you can find any problems?

[vv8]

What size are your slicks? I ran my 28's no wheel spin at all and I cant get below 2.0x what gives? My setup has to be capable of pulling some better 60's I am not sure what to do.

When will you be going back to HRP? Would you mind if I roll with you to see if you can find any problems?

28"x10x16 slicks hoosier, it must be the tune? Might be going friday night, I will let you know.

[-HIC-]

28"x10x16 slicks hoosier, it must be the tune? Might be going friday night, I will let you know.

Let me know I will be there for sure.

[bluecajun5.3]

that's a good start.
what i think is happening is in the heat the pcm is pulling timing out the hole b/c of high iat's causing your 60' to be so low. figure if you could get them down to 1.8's that's 4/10's you pick up in the 1/4 easy.

[vv8]

Let me know I will be there for sure.

ok will do.

[-HIC-]

that's a good start.
what i think is happening is in the heat the pcm is pulling timing out the hole b/c of high iat's causing your 60' to be so low. figure if you could get them down to 1.8's that's 4/10's you pick up in the 1/4 easy.

What RPM are you launching at?

[bluecajun5.3]

What RPM are you launching at?

1500

[vv8]

here ya go bryan, this is my truck to help you with friday night.

[yellowdemon327]

here ya go bryan, this is my truck to help you with friday night.

HOLY $HIT!!!are those tires actually off the ground????? they really look like it!