Forum: Powertrain

This looks like a very nice setup for beefing up the 4L60E. In combination with a shift kit, etc., I bet the shifting is awesome. However, a...

Hey I have a 99 ecsb with a 5.3L and when I get in the truck for the first time the gas peddel is extremely hard to press. After stomping on it once...

:help: Sorry in advance, I know this topic has probably been beet to death an reborn again over and over, but here goes. I have always run true dual...

i have a trans temp and a water temp autometer gauge anybody have a diagram or any tips on installin em ???? like where to put the temp sender thing...

Will efans off a 98 trans am work on my 99 z71, or will only the ls1's work.

i have an autometer tranny tempo gauge and need some help/info hooking it up....

This morning trans started slipping upon start and then slamming into 1st gear. I haven't even tuned the truck to max potential yet. Is the 4l60e...

Okay Dudes, here's the scenario, LR4 + Nelson Tune 4L60E, not fully rebuilt, but with upgraded accumulator pistons, servo check valve, separator...

Im getting ready to do my exhaust and would like some opinions. I have a rcsb Z71 and just starting to mod. I've ported and polished the tb,...

how difficult is it to rebuild a t56 tranny thanks

just ordered some ceramic edlebrock shorty headers... how hard/long is the install ??? i was just wonderin becasue im gettin em tommorrow and i get...

I need valve springs, but i figured while I'm in there I'll change the cam. Can anyone recommend a cam to give a decent idle and everyday...

Hey I was just wondering if what you guys think about the AFR cylinder heads. Just doing some homework so any info would be great.

in the directions to install my headers it says to use the stock donut on the passenger side but it wont fit inside the header like it would the...

Need help :whack: How much cam are stock valve springs safe for? I've never done a cam swap in a gen III motor, only old ass 350's. Wanting to put...

My truck has the Z83 suspension & I am trying to find what the color was of the original shocks (blue or black or ?).

I was aware of two Transgo kits for the 4L60E, the HD-2 and FSK, and saw another, the "SK", mentioned in another thread. Can anyone summarize the...

lol i broke the bolts that hold the EGR valve on the exh manifold and now it sounds like a shitbox hah well its an excuse to buy headers

Today, I recieved my transgo hd2 shift, check valve, Sep. plate, 'vette servo, and the blue assembly glue today. Tommorow I will buy the GM...

put in my vette servo today and it came out as a whole unit so i could disasemble it on the ol bench but i fuckin broke the e clip what a pain in the...