Forum: Powertrain

can i install a 160 thermostat on my stock computer?will it hurt anything? thanks danny

Ok, check my Sig. and tell me what cam would give me a little more low and alot more mid range juice? I dont need power at 130mph, but want to get...

There has been alot of discussion about what lengh push rods to use with the Z06 cam in the truck motor. It seems like the consensus is around a...

I know ceramic is the best. But what do you guys think about Aluminizing Headers, anyone doing this? I think I have my 02 problem in check with the...

Anybody know if front brakes from an 05 will retrofit to an 04 gmc.both are 1/2 ton 2wd ext cabs,I want the bigger brakes upfront. :bash:

I ordered the converter today, can't wait to drop it in. That'll be my last mod before I drop the motor and tranny in. I just hope it's enough...

Ok, I just got this shift kit (Transgo and vette servos) in last week and have been making fine adjustments (with tuner's help) in the tune. When...

what are the major differences also anyone have any vidoes of either??

Man ..i cant wait for my shackles to come in. I ordered them saturday hopefully by the end of the week Ill have them. I also have stainless steel...

i have a 1994 4x4 suburban, we pulled motor, tranny, transfer case or whatever its called that controls the 4 wheel drive. to get out the transfer...

I installed a set of Hooker lt's with a y/pipe a few weeks go. Im still using the factory 02 sensors and not throughing any codes but the 02 data is...

So like the title asks? Anyone have any issues? Anyone feel the benifits? What are the best quality pulley sets available and where?

After doing a Transgo and servos mod my 1-2 shift is very firm and the 3-4 is firm but not as strong . At less than WOT the 1-2 chirps my 32"...

i installed my shorties, and bolted rigt up will i need to cut pipe or flange to make them fit any advice

Guys, Where does the common shim to 1/8" flexplate to TC lug dimension come from? I do not understand. Here is the the clearance I have with my...

I own a 2001 Tahoe Z71. I want to put a limited slip rear in and just read that the 2WD models came stock w/ a limit slip rear. Will a rear out of...

FWIW--- As of Jan 30, 2006 GM has gone back to greasing shafts only and no longer replacing them :bash: . Took my truck in this morning to find...

well its about that time to use the good ole christmas money to start ordering my 2/4 drop. so this is the check list. feel free to correct me if im...

Ok, I am still a ways from being able to do a swap. But, I am wondering what the pros and cons would be between a 6.0L vs the LS1. and how bad...

I was wondering what are some suggestions for a quiet, good flowing muffler? I don't have cats anymore so that will make a difference. I just want...