95 RCSB to LQ4/4L60e

[BlueMagicSS]

More wiring... :bang::bang::bang:




Blah...




Old Wires...








Installed the S&P Oil Pressure Sending Unit Adapter, OEM Adapter, and Sending Unit. I forgot to get a pic of the sending unit before I bolted the intake down, but you get the idea.




Power Steering Hose




Heater Hoses Routed...




The owner wants to use the stock Battery Box and just use a cold air intake, so I'm using the OEM Battery Cables. Here is the Cable routed under the TB to the Alternator






S&P Water Temp Sensor Adapter




Mounted the Electric Fans on the Radiator, Using a Nelson Performance Fan Wiring Kit to wire up the fans, pretty straight forward install




Mounted the OBDII Connector under the dash


Still have to finish up the fuel pump, drill the trans crossmember, Connect the Trans Lines, Y-Pipe, and The Solder the Stock Harness into the Nelson Harness.

-Matt

[myzterray]

nice build...quick question..why did you put the sensor adapter for the coolant temp in the rear of the block. why not use the one in the front drivers side.

[Botlfed]

glad all these projects are going on, im about to start on a buddies truck 94 model, even though its not my truck i gotta be schooled, im supposed to be the guy that knows whats going on

[DINK]

lookin good!

[myzterray]

hey whaats the part number for those fans? what size are those?

[BlueMagicSS]

hey whaats the part number for those fans? what size are those?

They're from Northcoast Performance 16" Universal Fans Part Number #2054S

[BlueMagicSS]

nice build...quick question..why did you put the sensor adapter for the coolant temp in the rear of the block. why not use the one in the front drivers side.

Because the one for the LS PCM is in the front Driver's side, So the one on the right rear is for the gauge only

glad all these projects are going on, im about to start on a buddies truck 94 model, even though its not my truck i gotta be schooled, im supposed to be the guy that knows whats going on

This isn't mine either... But I will be doing my 89 K5 Blazer soon enough.

lookin good!

Thanks... It's getting there. Just got the fuel pump back in. Now I just need to finish up the wiring.