1993 OBS Speedometer and Cruise Control wiring

[blownshovel]

1995 silverado 2003 6.0 TBW
I was so happy to get running and thought I'd get back to cruise and other items but haven't over the past 4+ years. Now I also would like to get the cruise control working. I had the info and marked some wires but now... can't find it. Anyhow I will send redheartbeat a message or if soemone could post up the diagrams referenced early in this thread it would be very helpfull.
Thanks

The Mitchell schematic is much better for the 95 even if it's the same.

7 - light green
8 - black and white
9 - pink
10 - white
11 - dark blue
12 - purple and white
13 - brown
14 - dark green and white
15 - dark green

Compare these to the stuff Greg emailed you to confirm.

[T-Stark]

anyone know how it would be on a 89? and my speedo dosnt work fyi

[88stepside]

anyone know how it would be on a 89? and my speedo dosnt work fyi

1989 trucks have the VSS signal going to the speedometer first, then the signal is "conditioned" and sent to ABS, cruise, and also to original PCM. Once you get your speedo working everything else should work also. Since you have an auto trans with 40 tooth reluctor wheel VSS you can simply run the VSS wires to the speedometer, they should be purple and yellow and they are twisted together. To send the signal from VSS to new ECM just splice into the purple and yellow wire anywhere it is convenient.

To calibrate speedo on 88-90 trucks you will have to do the cluster calibration.

I just went through all this on my truck, but EVERYTHING works now.

[T-Stark]

To calibrate speedo on 88-90 trucks you will have to do the cluster calibration.

how do i do this????? sorry just trying to get all the info i can, or a link so i know what im doing when i start it


Thanks man!

[88stepside]

Check these out:
http://www.fullsizechevy.com/forum/a.../t-155414.html

http://www.chevytalk.org/fusionbb/sh...hp?tid/258562/

Basically, back in the day before DRACs and VSSBs they had the speedo "settings" for tire and gear inside the cluster. The way to change them is not hard once you know how.

I still have the parts in my garage, I'll dig around tommorrow and see if I can find the part numbers.

The second link has a great way to replace factory "clip" with a dipswitch.

[88stepside]

Check these out:
http://www.fullsizechevy.com/forum/a.../t-155414.html

http://www.chevytalk.org/fusionbb/sh...hp?tid/258562/

Basically, back in the day before DRACs and VSSBs they had the speedo "settings" for tire and gear inside the cluster. The way to change them is not hard once you know how.

I still have the parts in my garage, I'll dig around tommorrow and see if I can find the part numbers.

The second link has a great way to replace factory "clip" with a dipswitch.

25085515 and 25084374 are the GM parts we used to use to calibrate 88-90 C1500 speedometers. Hope this helps.

[T-Stark]

Thanks man I'll try and get this working soon I'll pm you if I have any problems