Why not just buy a 6.0 take out and swap it in? I think that would be cheaper.
EDIT.....Just realized I missed page 2......
Why not just buy a 6.0 take out and swap it in? I think that would be cheaper.
EDIT.....Just realized I missed page 2......
Last edited by jpodell; 12-29-2010 at 10:04 PM.
If I were to go back I might have done this to my stock 5.3. First thing get the trans all built up. Then 4:10's and a Trutrac. Then cam ls6 intake and maybe lq4 heads. And don't forget the nasty stall with that trans. Still not the cheapest rout but cheaper than a built bottom and safer than nitrous. Rev it to like 6500 maybe 7k and it would be fun to drive.
That would be retarded. Why would you get heads that lower compression and don't flow any more?Originally Posted by emmerich5.3
T-RAV99 GMC | 5.3 | Skinny White Guy Tuned
what all would i have to do to my trans to hold a 75 shot??? jw? thanks guys
Built 2 Run! 6XX HP/ 6XX TQ
Don't even bother with a 75 shot. Go to a 100 or 125.
Shift kit, servos, and a trans cooler. Or just get a fully built unit from somewhere.
T-RAV99 GMC | 5.3 | Skinny White Guy Tuned
o kk, well maybe ill look into that? i got vette servos is the transgo 2 shift kit any good? and ya i been looking at trans coolers whats a good kit to use if i go that route? thanks trav 4 the help bud
Built 2 Run! 6XX HP/ 6XX TQ
You're right I wasn't thinkin. I should have said L92 heads. But I haven't looked at the CC volume for those heads yet.
Looks like that would raise compression too. Maybe just some porting would be best.
You can't use L92 heads on a 5.3 either. Has to have a 4.00" bore at least for the L92s.
Looks like I have some studyin to do lol! My bad guys.
Posting Permissions
Reply With Quote
