well, didnt get anything done on the truck other than order the parts to change the lifters in the motor.
if you do a NNBS engine 4.8,5.3,6.0 you need the following just to change the lifters.
(4) 12595365 (LS7 lifter trays)
(1) 12499225 (LS7 7,000 RPM lifters)
(2) 17800568 (head bolts for newer motor)
(2) 12589226 (Gen IV head gaskets)
cam kit if you plan on doing a cam too
12499228 its normally back ordered.
just figure out what you need and order it seperate. it's a little more costly IMO but you wont have to wait lol.
E-fans and Nelson harness should be here today.
parts still needed:
34" Radiator
SS Braided Line
a few more AN fittings
Fuel pump
Nelson Harness which will be ordered as soon as the lifters are changed
98 350 throttle cable and cruise cable
3:73s detroit tru-trac
heater hoses and clamps
Tune
custom 3" exhaust
Last edited by keniff; 09-15-2009 at 12:46 PM.
2008 GMC CCSB 6.2/6L80e swap
Gen IV 5.3/60e swap 1994 ecsb W/T
Reply With Quote