About to attempt hooking the wideband up to HPT. I'm assuming that I use the green connector that plugs into the side of the HPT cable. Then leave that lead in the glove box until needed for logging? I know others have already done this, just looking for ideas for a clean & hidden install. Any pics would be nice.
Also curious about how to set up a histogram for data logging with the wideband. Thanks in advance.
2001 ECSB 4x4, 5.3, Radix, 3.0 pulley, VHP Trucker cam, 216/224 .551/.551 115 lsa, 1.8 Crane roller rockers, 4L65E, Yank SC3000, 3.73, Cal-Tracs, HPTuners.
The histogram is already set up in the scanner. And in order to read on the bottom of the table display there are the input selection you have to click and insert a PID, and there should all ready be one made for that wideband. You may have to adjust the PID to fine tune it to what your gauge is reading. And yes you use the green connector in the side of the box. Check out the help menu in the scanner there a lot of good info there about setting everything up.
what brand WB? FAST isn't setup in the histogram, gotta do that one yourself if you have one.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
AEM.Originally Posted by RedHeartbeat
Posting Permissions
Reply With Quote
