Below are some of the parts I have laid out. You experts let me know if anything appears to be missing. Primarily for the cold side. Put in some of the 4" stuff too for kicks. The smaller silver 3" pipe will be for the cold side. I have a 4" to 3" reducer to come off the throttle body. I'll probably cut the 90 degree turn off the 3" pipe and use that for the turndown. Then a silicone coupler. Don't think I have enough 3" for the piece going down unless the fitting for the blow-off can be covered over. Will be able to use the 45 degree piece and silicone couplers to come off the drivers side of the intercooler. Again, will need more 3" to meet up with the downpipe. Use the 45 on the other end of the pipe to connect to the downpipe. Will have to get some 3" pipe - I think Billy has some.
What's this??? Has a check valve (?) on the end. Boost gauge related?
Oil Drain...I assume the fitting on there is the one I use to thread into the oil pan:
Oil supply line. I've got the 21/64" bit and 1/8" NPT tap. Think I just need the fitting to thread into the oil pan.
Reply With Quote