Had a broken exh. manifold bolt and now I broke an easy out off in the broken bolt. Looking for 1 or a pair of reasonable priced.
Prefer somebody local around SW Houston....
Had a broken exh. manifold bolt and now I broke an easy out off in the broken bolt. Looking for 1 or a pair of reasonable priced.
Prefer somebody local around SW Houston....
89' GMC RCSB 6.0L LQ4, T56, 4.56 Gears
Have you tried to weld a nut to the broken part to get it out?
2006 Superior Blue Trailblazer SS AWD, Stock as a rock
Sold: 2002 GMC Sportside Denali front end with a 2002 LS1, FLT level 5, Yank 2600, Trick Turbo, T76, Nelson intercooler, 60LB injectors, Warbro fuel pump, Eaton locker, Magnaflow, 3.42, Nelson Performance Tuning (speed density).
Sold: 1981 GMC LB RC 1500 2002 4.8L 4L60E 12 bolt 3.73 Richmond Lock Right AC PS Nelson Performance tuning
man that sucks. might be time to upgrade, you can call up patriot performance and get a set of new 243 LS6 heads with LS6 springs for 450, and they will boost your CR alittle for alitle more power.
Somthing to think about.
it broke clean off even with the head. then thats where I f'd myself by trying to use and easy out.Originally Posted by GMCwantsLS1
i have drilled down somewhat and Im certain the easy out is gone
and i have drilled off center and at an angle.
then i started a new hole
ARE these bolts hardened? they r a bitch to drill
Damn tell me more. 450 sounds preeeeety damn good
shipped? might just do a cam too....there goes my budget
i wonder how much CR it will give me?
Gotta consider they get heat cycled while the truck runs. You can always put a helicoil in the hole if you get it oversized a bit while trying to fix it.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote
