Well i just pritty much finished my converter swap in my truck, everything went smoothly till right at the end. My troubles are that when i mated the tran to the motor every thing looked fine, it seem flush with the motor, so i began two put the 4 bottom bolt on, then i went to the top on the motor to put them in. well by mistake i put a bolt in the 7 middle hole and began to tighten it, when all of a sudden i heard a bang. That piece of the trans snap right off, so that led me two believe that the tran was not all the way seated down. well when i look through the bottom is sit flush with the motor. then separates at the to just a tiny bit, what the deal here? also im having a hard time getting my tran dip stick in. Need some advice guys.