Forum: DynoData

how much hp do think i will have and how long will the 4l60e trans last me.

This was your 12.53 run. I thought it was cool you "got proof" besides just the timeslip sheets. They've got some really cool videos.

Well guys,finally had my dads 02 ext.cab Z1 with a 5.3 dynoed with the Lingenfelter GT2 cam!Well needless to say I was impressed again with...

Well, now I am depressed. I took the truck to the dyno today and got the bad news, it's a POS. It layed down only 244 HP and 251 TQ while pinging...

this summer when i have everything basically in the truck how much hp do yall think its going to have a the rear wheel. mods im planning on having...

My Webpage Well after getting the new cam in and some minor tunning. RAF, VE and timing I decided to get some base numbers. I guessed it would be...

Cant say i'm really happy. I was hoping for a small improvement at 3500 but actually lost Torque across the chart (until 4800 where previous tq...

just to show yall some of allen's magic. this is on 2nd mail order tune. shortbelt and open exaust out the y. shortbelt yeild a 10hp/10tq gain. ...

http://i17.photobucket.com/albums/b92/kevm...yno02-11-06.jpg

Well, i realize that its not a LS1, but i just thought it might be of interest for comparison sake. 1990 F250 EC 460/E4OD -removed air filter @...

For a N/A 5.3 L33 ??

Hey guys I know its a TA. BUT DAMN. They are still tuning on the TA we built a 408 for but, its allready up to 640hp at 5/6psi. :eek: They had to...

Here you go buddy! Great numbers. btw, the base run we did before the shaft broke was about 325hp and 400+-tq, it was hard to guess the readings...

I am new here, but want to see what else I can get out of my little truck. 2003 s/c s/b Sierra LQ4 .030 over Lingenfelter GT7 cam, comp valvetrain,...

http://www.speedworldmotorplex.com/calc.htm Estimate your horespower based on weight vs. e.t. or trap speed Ran mine at 13.41 and 5250 weight. ...

hey guys, while down at Nickens last Friday dropping off my engine, there just happend to be a stock LQ9 on the engine dyno. The engine wasn't...

better late than never :laugh: Here you go, this one put out some nice numbers as well! You can see HP kept climbing, so I'd expect just over...

Here you go SC, hope you don't mind me posting it. Here is the link to the chart. It made: 338HP@5666rpms - 344TQ@4763 SCIV DynoChart ...

Allen, just because I have a bad memory can you throw up my dyno sheet when you get a chance?? :yawn: It's not like you are busy or anything ...

Hey whats up--figured I would ask you guys about my truck since you all have been into the 5.3's more than me--I got a set of headers (Gibson) and...