Forum: Powertrain

Anybody get the scoop on the recall for silverado's etc, something about leaking brake fluid?

will a 4L60 out of an 02 f-body retrofit or swap over to a 94 rcsb 4.3 that already has a 4l60 in it. what will it take to make it fit? thanks

What gives the '05 trucks more power... like some have the 310hp. Is the cam profile the same? I know the e-fans add a bit of power, but I'd...

I have about 85k on my truck right now, and I have checked my brake pads several times since I have had my truck and the brake pads don't seem to be...

I'm trying to get ahold of a new set of rings for my 6.0L engine that I'm putting together. I have a 6L block with 27K miles on it that will be...

:laugh: ,got two plug wires that hit the headers and burned one pretty bad.So I ordered 8.5mm wire & terminals and made my on.But keep sending...

What could be causing this? Im using 93 octane gas. Its feeling like its straining to go anywhere. The fuel filter and air filter has...

I was wondering what would keep causing this code to come up when the temp drops below 20 deg, It never comes on in the summer, just the winter

Ok, I am getting ready to start saving money to do little things to the truck. Just bought a house in October, so I am a little broke. I have an...

hey guys, i have a 99 silverado NBS with the 5.3/auto 3.73 rear gears.. i am soon to be running 20x9 wheels with 305/50R20 nitto terra...

I'll pick up ET like a mofo, but no MPH right? Or will I gain MPH? I don't think so as it's related to power... not being undergeared. Any...

can i get long tubes with a 5/7 drop on an OBS?

I changed the oil in my mom's 2000 ECSB 4X4 4.8 today and there was water on the oil fill cap. The oil in the pan did not seem like it had water in...

I have a 99 silverado and am looking to do an electric fan set up. I was wondering if I should use a f-body set up or look for an after market fan. ...

missing when I start to get into boost.Sounds fine running around town, just when the needle hits 0# on the gauge it starts to miss. What could...

I just got my heads built up and milled. Since it will be running a little more compression and I upgraded from 1.5 to 1.6 rollar rockers , and also...

Well i just finshed putting no the headers i had on the shelf for the last 4 months. Has anyone else had problems with Edelbrock? The Y-pipe was...

What is all involved in taking the throttle body off.im sure it needs a good cleaning.ive takin the intake off and cleaned it but im sure taking the...

these are the autolite replacxements for the ngk tr55. i ran two or three times on the juice. i have them gapped at 40. well had. the last two are...

Right now I am running 17inch wheels with a nitto 255/50 which gives me an overall diameter of 29 inches. My stock gear ratio is the 3.42. Is this...