Forum: Powertrain

Well I'm changing my setup around a little this year. Little bigger cam and a performabilt trans with one of their converters. Originally was going...

Well, I leaked it out earlier so I figured I'd start a topic concerning the swap from a stock LS1 intake with the factory 98 T/A throttle body to an...

does anyone know the cheapest place to pick up a set of 4:10's

This question has been eating my brain for a few weeks now. When i drive i hear water slushing around. for example if you take a water bottle fill it...

i just saw pics of them of here and went to there web page to check em out. pretty good price but what do you guys thimk about em ?

Well I had one exh. manifold bolt break right off flush with the head. So I drilled a little bit and TRIED to used and Easy Out to extract it. Then...

Well, my problem is stated above. I'm about to take a drive for a couple of hours and see if things get regulated by the PCM, but thought I would...

OK, which bolts must be replaced when reassembling a 5.3? I know the head bolts are stretch bolts, but what about the connecting rods, main caps, etc?

Does anyone have this exhaust system, I seen the price of it and it's a bit on the pricey side, sounds good on the site, anyone have this on a SS? ...

Ok guys, so when I start my truck..I get a slight "knocking" sound for the first minute or so. Now that it's getting colder it seems to last longer...

does anyone know if the bbk intake manifold for the ls1's and ls6's will fir on the 5.3's?

How many miles do you have on your Silverado? 68,XXX here!

is anyone running the granatelli MAF sensor and do they really help as much as there suppose to?

what size primary/collector you need for headers? I see 3/4 and 7/8 etc but have no idea what I should go with.

i have a 1990 standard cab short bed , TBI injection,headers,chip,4.11gear...i am wanting to switch to 6.0 iron block i have .what do i need to...

Fuel pump went out. Basically no warning at all. Just a bit of a chug the day before then today, BAM stalls out and won't start again. Workin with...

Is this what I need to intall to the fuel rail test port: Anodized Straight -4AN Female to 1/8" NPT Male Swivel Coupler Thanks, S.C.

so which factory produced head will boost comp. on my LQ4

Hey guys Im doing a T56 swap in my 06 rcsb. I know a few guys on here have the T56. I was wondering which gears rear end gears I should run. I want...