Forum: Powertrain

So I found a good deal on this cam but im not sure about all of the converter sized and whatnot. I am installing a 2500 stall converter this week. I...

I have 92 Chevy w/5.7. I was replacing the battery and alternator and while they were out I washed the engine compartment. The engine fired right up...

Doing a McGaughy's 4" drop in the rear with shackles and hangers, and a their dropped spindles in the front. I'd like to tighten the shocks up too....

The cam in my Denali has .550 lift, I got to thinking the other day is that too much for my stock springs?

The Trans Am I put the engine in has received a lot more mods and I need people with direct experience with the T56 in the F car and aftermarket...

Figured I'd check here before tearing into it. Mom's 02 4wd Tahoe. Has autoride on it. The truck feels REALLY loose. I checked tie-rods,...

Has anybody used the Lunati VOODOO cam 60510 or 60511 in a LS1? Iam thinking about trying one of these in my 2001 ECSB(Z71 4X4) with 4.10 ...

I found a deal on Gm 28.8# injectors for 50 shipped. I was told before that my truck has the 19# ones stock, and with plans shortly of having spray I...

Has anybody used the Lunati VOODOO cam 60510 or 60511 in a LS1? Iam thinking about trying one of these in my 2001 ECSB(Z71 4X4) with 4.10 4l60e,OBX...

Well? Thanks guys.

Gotta 99 silverado with a 4.3. The original fuel pump went out at 170k replaced it with the full airtex unit from advance. that only last 6 months....

ok so i got my truck back up and running and it was running fine. But now once i go full throttle its really really sluggish and my aeroforce gauge...

Today, Vista 4.8 helped me remove the blocks and install 2WD u-bolts to lower my truck. We went into the whole procedure blind because we couldn't...

Does anyone know where I can find hobbs boost switches and some decent solenoids?

Well after having the cam in and headers, i went back to stock and Nelson Performance sent me a "stock" tune, and i started to have a bad "jerking"...

Vibration after i mounted some stock z71 17's from 60+ mph, i got all 4 balanced twice and rotated once and still the same vibration on the steering...

was looking at getting a springtech spindle lift kit because they are almost half the price of a cst, my question is does the springtech need the...

i have a nnbs rcsb with a 4.8l its mainly just for show... im now wanting to do a cam swap and never really knew much about cams. not looking to take...

my buddy has an 06 vortec max. yesterday it just quit running. He thought the altenator was bad and it was when he had it tested. Once he replaced it...

Hey guys I was wondering if anyone has had this problem or heard of it? I put some new rims I bought from a friend. Had them checked out and they are...