Forum: LSX Truck Conversions

Well i missed up my engine with N2O I was going to put the same setup back in the truck. But then i was thinking i was not to happy with the power....

I know a lot of discussion has been done about this but I couldnt find much definate into which ones will fit and which ones will not and why. ...

I got the 6.0L running last night, but the transmission isn't moving when put into gear, the dash gear shift light doesn't light up either. At...

11-18-09: This is my LQ4 that i got out of an 07 3/4 ton work truck. I will be doing my research and taking my time picking my combo out. I am going...

how can i get rid of the old tbi harness on my 1988 short bed? im doin a ls swap n i wanna keep the needed wires for the swap like the key powers,...

what shortie header can i use on my 91 chevy with a 6.0. i have the shoenfield long tubes now but cant use them anymore. i am putting airride on and...

So seeing as im basically new to this forum AND trucks i had a few questions that i figured someone could explain better than google. 1. I have a...

Hey guys, first of all I would like to say this site is great! I've been reading around this site for the last few months to get a good idea of what...

on a 73-87 swb? i know the 90 was bigger tanks and was wonderin if they will fit on a 80

I guess that during the process of installing my new fuel pump I manager the mess up the sensor on my fuel pump hanger that makes the gas gauge work....

1992 k1500 using 2004 k2500 parts: So I have a donor 2004 k2500 chevy that ive been picking parts off of. So far ive got the 6L and 4l80e and t-case...

I am gearing up to swap a 00 LS1 (WS6) engine and a T56 trans in my 01 Silverado 4.8 / 5 speed. From what it looks like and from talking to Allen if...

Hi Everyone, I am in the midst of getting the engine up and running and ready for install (2004 5.3L engine and tranny into my 1972 GMC Jimmy...

I have a 4.8 shortblock gen IV I've seen the 5.3 and if im not mistaken they share the same bore - the difference is the stroke. in order 2...

will i hav any clearance problems with the factory ac or will i need to move the ac?

I just joined this group and I looked through the posts and couldn't seem to find what I was looking for. I am new to GenIII engines and want to know...

I am getting a LQ9 Drive by wire motor to install into my 80 C-10. I want to run a LS intake and keep the drive by wire throttle body. What...

Ok on the OBS chevy's for whom is doing like an lq4 swap. I understand the problem with the a/c bracket, it brings the compressor too low and have...

Hello, I'm new here and I already check in and said hello. Anyway, I had this engine that someone gave me and I was wondering is it a 5.3 or 4.8...