Forum: LSX Truck Conversions

Newbe here. I just picked up a 1996 reg. cab short box step side. :hyper2: Has a 4.3 with a bad cam.....so I've been told. I already have a 2008...

Got my swap all done this weekend. Did have the ECM tuned but it must not have been tuned for the mods done to the engine. So, who is a really good...

I've got a 1990 rcsb Silverado 4x4 that I will be putting a l92 with a 6l80 in and I'm having a hard time finding 1-7/8 long tube headers. Anyone...

Hi, I'm getting just about finished with this swap I began in September. Work has really put a damper in my timeline, but so far, all is well, and...

No surprise - the stock 5.3 A/C compressor will not fit my chassis, but I knew this going in. After talking with a lot of different aftermarket A/C...

The back story. I recently swapped a 2001 5.3 LM7 into my 1998 K1500. I rebuilt the engine but reused a lot of the peripheral components. Since...

Hows it going guys, here are some photos of the build. Its almost finished. 6.0, 317 milled heads, full bolt on, cammed, 4l80 , custom harness, e...

hey guys, new to this forum. i've posted on a few others for a while. and asked the same question as well and can't seem to get a bite on it. anyone...

So I know this might be worn out by now and I've done my fair share of research. But it seems there's just a couple things I can't figure out. Let me...

I may have found an LS1 from an 02 Z28 for my 98 Tahoe. I have the Lextech A/C kit which I just realized wont work with the LS1 brackets. Question...

What issues, if any, will I encounter if I decide to to an LS swap and use the matching trans from the donor truck? I want to drop a 5.3 or 6.0 in my...

Bolting an ls1 flywheel into an 06 lq9 but there seems to be a lot of slack on the flywheel, is there an aftermarket flywheel bolt for this set up? ...

Hello. Let me first start by sayin that I have researched and been thinkin about this for a while now. I know I will have guys say, "why" etc. So...

Hey guys. As stated I have a 84 c10 regular cab short box swb truck. I have dual I believe 16 gallon tanks. Now I bought an 87 sending unit with...

There are lots of threads about deleting the existing EGR parts off of our engines, but I haven't seen any information about 5.3 engines never having...

Ok guys my first post, I use the search a lot but I can't figure this one out. I swapped a 2003 5.3 from a van into my 1993 c1500. I used the...

got my 97 truck lowered 4/6 and the stock truck oil pan has smacked the ground a few times and i want to get a shorter one before something bad...

Im in the early stages of planning an LS swap into my 98 2 door Tahoe 4x4 and IM currently looking at engine options. I plan on repinning my OEM...

What all is required to get my speedo working, here's my set up... 1990 obs lq9 swap 5 spd, nv3500, or as they call it the GETRAG tranny. any...

Has anyone used lokars lok-aca-1800 on there 88-98 ls/4l80e swap?