Ok, guys.

I have the "LS1" stainless emblems made. They are made from stainless steel and are 1.25 x 6 inches and are 3/16" thick and are polished. You can clear coat it if you want, that way it will be very easy to clean.
I cut one from paper during the testing stages and it seemed to be just the right size for a truck , right under the side molding or on the tailgate somewhere.

I'm going to put one on each side of the truck way down below, where the molding was, right below the side mirrors. I think that will look just right.

Here's the price breakdown:

They cost me about 15$/each. I'll add about $3 for shipping, then there was a one time fee of $25 for setup (I'll divide that fee up)

So, if I can sell these things for $20 will any of you buy them. You would be supporting your ls1truck site and allowing me to purchase additional drive space.

I already had 5 of them cut and they are ready to cut as many as we need.

btw, I haven't forgot about the "Powered" part. That is coming shortly. I'm trying to figure out a way to attatch the powered to the bottom of the LS1 badge and not have any piercings (that costs more $&#036.

thanks guys,

allen