adding hydraulic assist steering
The steering has been pretty sloppy on my 4x4 on the highway so instead of just replacing the steering box i figured i might as well add the steering assist.
The pump was needing replaced also so with this kit it replaces all of it.
ill get some pics of it when i get the truck back from the shop.
Have you been able to use the truck yet on your property?
1951 3100
1984 C10
yes i have used it some, but ran into belt slipping issues again which are being fixed also.
That was my next step, but then the tranny went. I looked at the RedNeck ram. Htey modify existing box to keep cost down.
Pics!!!
2013 CC 5.3
81 C10 LS1 project
its almost done
a couple crappy pics from my phone, he is making some pretty cool traction bars for it also.
finished pics!?
2009 CHEVROLET 1500 with a MONSTER 4.8 between the frame rails!!
Tuned by LSX Powersports ~ 4.10 ~ JBA Shorties ~ 4" Inlet/Outlet Spintech ~ Airaid Coldair
CST 3.5" Spindles ~ Camburg Upper Control Arms ~ 2.5" CCM ~ FFR Tie Rods
Full Throttle Suspension 3" Lift Blocks ~ Soft 8s wrapped in LT285/70/17 Silent Armors
yeah it is all done, holy crap its running good also, lights up them 38" mud tires like nothing lol ill get some pics of it soon, just been super busy.
here's some pics, the steering is like a Cadillac, wheel turns with no effort at all, also had a sway bar put on in the front and a traction bar in the back.
niiiiiiice
blown transmissions are about as useful as 97% of the guys on this forum
Damn, you don't play games! Badass truck.
Big slow mud truck with a TUNE!!!!!!
Posting Permissions
Reply With Quote
