Most likely headed to Long Beach to pick this up next week.... lol...
http://www.dezertrangers.com/vb/truc...ies/154257.htm
getting it for my dad, I can't keep him out of mine so getting him is own to play with.
Most likely headed to Long Beach to pick this up next week.... lol...
http://www.dezertrangers.com/vb/truc...ies/154257.htm
getting it for my dad, I can't keep him out of mine so getting him is own to play with.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
I really know nothing 'bout pre-runners but 14000 seems like a steal for everything done.
2006 SilveradoLittle Black Bitch
I just want to hear Big Papa roll up with 4 L7s banging...LOL, u may need to confiscate those before delivery. Probably could hear those as he went by my OP entrance.
--2013 CC Z71, Edelbrock charged, cam, long tubes, 4.5" Zone, 285/70/18 KM2s on Gear Big Block, Kenwood system, LineX, Retrax, Katskinz, NFab.
--2012 Dmax CC Z71, Cognito UCAs, braces, Fox 2.0, LineX, Nfab, Retrax, Ranch Hand Front/Back, Custom Katskinz, Black Gear 18x9 wrapped in 285/70/18 Toyo MT.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
Nice. I was thinking the same thing about it being a pretty good deal. But i dont know much about them either
Ya, it's a great deal. But the market is slim for highly modded stuff like this.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
I sure wish I had a digital camera to take pics of my 1992 back in 1999 when I had it setup with the Fabtech pre-runner setup! Had the lift spindles, a-arms, coil springs and lifted it a mile in the air. Rear had 4" lift blocks. Truck was powered by a 1993 Corvette LT1 with a factory truck 5 speed.Took all of it off when it was too dangerous to drive on the street because the early version of their spindles were crap and the front tires would literally roll under the truck (outside edge of the tires) during turns.
![]()
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Looks like a good deal my friend.
2013 EC Silverado aka redruM (Just a couple bolt ons.)
2007 RC Silverado aka ?
1998 Trans AM aka Red Dragon
"Your pull your truck to the track on a trailer, I race you with a truck that pulled a trailer to the track."