Hello, I just recently recieved my converted Nelson wiring harness, I have a few questions. The truck is a 95 chevy 1/2 ton 2wd, and I am using my original 95 4L60E, the harness I sent them is the one that came off of my 03 6.0, my motor was out of a 03 2500HD with a 4L80E. So I had them convert my harness to run a 4L60E, and also remove the rear O2's, evap, etc., first question is the VSS sensor plug is different, can I solder on my original 95's pigtail to the new harness, and have it work, also I guess there is not supposed to be anything hooked to the module on the side of the shift arm because that wiring has been removed. Second question for some reason they left all of the air compressor wiring in my harness, I thought it was supposed to be removed, because I would be using my 95 ac wiring, am I right or not?. Third question there is a large white connector about 12 inches from the main 2 computer plugs, I have no idea what this is for, or if it's needed. It doesn't match up to anything, I already have the complete motor hooked up. Thanks for any input, and I'll probably have more question's. Thanks