Quote Originally Posted by airdeano View Post
ive tried to just order that power brake fitting with no luck.
ive got two in the manifolds and cannot remove them without
breakage. currently i have a vacuum nipple blocking the port
temporarily until i locate that fitting.

airdeano
Since mine was already broken off in there...i went to Menards Hardware store and bought a 90 degree plastic 3/8" hose barb fitting with 1/2" NPT threads on the other side...since that hole is .77 and OD of 1/2" threads is about the same, i touched the plastic threads on the fitting with a file (for clearance) and Hi Temp RTV'd that thing into it. I did that last night, so i'm hoping it'll be all dried and ready to test this evening. I need gauges though...this sucks...i should have run a TPI motor...