Thanks brother, I am happy so far with the progress, even though it's much slower than I originally wanted. On my other post I said I found a pinout for the cluster gauge to help take the guess work out of guessing which wire controls what gauge. This covers the clusters for both 91-prior and 92-up.



I also after messing up my water pump trying to tap it like a lot of people recommend (hole had substructure casting that interfered with fit), I figured out that I can take the factory sending unit and put it in the lathe and turn it down to 11.96 MM and then thread it to M12X1.5 to fit the factory bolt plug on the rear side of the passenger head. $58 learning lesson for the better though.



I still have a question about a wire left over from my gas pedal lead wires to the Tac module. One is a pink power wire, which I can figure out, but the other is a light blue wire that went to the C200 under hood fuse connector which states A10 L-BU 1320 CHMSL Supply Voltage/Stop Lamp Supply Voltage (KUP).......... What do I do with this wire? Also does anyone have the pinout for the 94'ish C100 pinout and the factory cruise connector pinout?






I would like to thank everyone on this forum that has helped me up to this point. I still have a little ways to to go, but everyone's input has been nothing but beneficial so far. Thank you all.