Midwest SS' Garage \ 408 project

[MidwestSS]

there is no dyno near me within 100 miles that can handle the truck AWD chassis.. and before anyone suggests, im not removing the front driveshaft to get it dyno'd.
as far as the track.. last time it ran, I got a 13.1 on the 1/4

[kerrige]

there is no dyno near me within 100 miles that can handle the truck AWD chassis.. and before anyone suggests, im not removing the front driveshaft to get it dyno'd.
as far as the track.. last time it ran, I got a 13.1 on the 1/4

Was it boosted at that point?

[MidwestSS]

yeah, but I was babying it down the track since we were working out the tune.
I had an issue where I slammed it from the line.. as soon as it shifted, I went into limp mode.. haven't figured that out yet.

[Frenchy]

Wait. It doesn't run for shit. And you're powdercoating the sway bars?

[MidwestSS]

it runs fine.. just needs some fine tuning, which ill get to.. wasn't built to be the fastest on the planet.. twas never the goal.. im coating these parts for my own reasons sir..
it only went into limp mode that one time when I was at the track, other than that its been fine.
then again.. I don't street race it, so it'll get lined out the next time im at the track..

[Botlfed]

I need to get my shit powder coated, looks like crap

[MidwestSS]

I got my new calipers today as well