Holly EFI Hi-Ram intake we just finished up.

[banker099]

Phuckin sik lookin when it fogs the camera!

Yeah that went all in my face!

[dropem]

HAHA!!! That's what she said!!!

[RedHeartbeat]

reminds me of "the moneymaker" intakes. Hide the plumbing better for a more stealthy appearance. Put the fittings at the rear of the intake in a location that is harder to detect.

[Botlfed]

yea can you PM a price for a 2 stage setup for up to 500 hit with this intake plumbed and ready to go. I know i have a direct port kit ordered, but thats pretty sweet.

[banker099]

yea can you PM a price for a 2 stage setup for up to 500 hit with this intake plumbed and ready to go. I know i have a direct port kit ordered, but thats pretty sweet.

$275 a stage, send ya a pm, we can work with you on your layaway as well if you would rather do this.

[sprayedenali]

how do you control how much fuel/nitrous is sprayed? different sized holes in the spray bars or is there a jet at the end of the bar? just curious.....

[NitrousExpress]

It works just like our plate. You put the jets at the end of each bar in the fitting and then you attach a line to each of those fittings and that is what gives you your control over the amount of flow.

Here is a picture of one with the lines attached. The arrows are pointing to where the jets will go.


Trey

[Botlfed]

No new pm's, ill just call tomorrow.

[Botlfed]

So I looked around about the intake and the tests are showing either good for high rpms or big cubes, will this intake be to much for a 6.0 with ls3 heads, I'll be revving to prolly 7k and spraying 350-500 as you already know

[NitrousExpress]

I personally thing this intake is perfect for a 6.0 or bigger in a truck because the longer runner give more torque down low than a Vic Jr. does.

Trey