project "GoNDown"

[RPM Graphics]

Man it looks great in there! I always liked your truck and that bumper. Lots of good info for me on your thread. Give us more pics of anything and what u cut out of the factory wiring. I'm deleting my abs as well.

thanks man, it's taking me long enough, LOL!!!!
on the truck harness i basically removed everything that went to the truck ECU, injectors, o2 sensors, egr, etc.....
i left a few wires for the a/c. then i had to sort through all the wires that go into the c100 connector on the firewall & figure what goes where, oil pressure, temp, speedo, tach, check engine light, etc....
it's very time consuming, but with the right diagrams it's, not too bad. what year is your truck? i have the diagrams for 96-98, which are different. i found out the hard way. my truck is a 96 & the first harness i got was for a 98. i didn't realize they were different till i had it all striped down, but i just consider it i learning experience, LOL!!!!
LMK if you have any questions. i'm by no means an expert, but i've figured a lot of this stuff out.

Where did you get that over flow tank from?

ebay. it was like $35 or so. they have some that look identical that where $100-$200, but this one works fine so far.