my first ls swap 1996 2 door Tahoe 4wd 385 Stroker to LQ4 cam headers **pics**

[HPICamaroSS]

I haven't paid much attention to the 4x4 part of the harness because I'm probably doing away with the 4x4 anyway.

No good! Lol thanks anyway. Maybe someone else will know that reads this. I just need to know where to tie in the 4x4 harness into the new standalone harness from nelson

[ccreddell]

No good! Lol thanks anyway. Maybe someone else will know that reads this. I just need to know where to tie in the 4x4 harness into the new standalone harness from nelson

I would imagine that you would have to tell Nelson that it was a 4X and then the harness would be marked. Either that or it would come as part of the harness.

[HPICamaroSS]

I would imagine that you would have to tell Nelson that it was a 4X and then the harness would be marked. Either that or it would come as part of the harness.

Nope I told them that and they said 4x4 isnt a part of their harness. There harness is just the engine and tranny, they said the 4x4 "harness" on the obs truck is considered standalone. What I am trying to figure out is where that gets its power from because its not actually connected to the engine/trans harness. Sry myzterray for blowing up your build page, ill move this to my build page lol

[myzterray]

No good! Lol thanks anyway. Maybe someone else will know that reads this. I just need to know where to tie in the 4x4 harness into the new standalone harness from nelson

would suggest call nelson and ask them. pretty sure someone there can help.