project "GoNDown"

[myzterray]

yeah, know where everything goes into the firewall is a big help. the wiring has definitely been he biggest headache of the whole swap, that & getting friends over to help, LOL!!!

yea i wish i knew what the wire on the other side go to. the one with the firewall grommet. after i cut off everything i got 4 or 5 wires comin from there that dont go anywhere. lucky u got freinds to come help..ive done everything so far by myself.

[RPM Graphics]

yeah, i have about 6 wires that i cut that go into the grommet, yellow, purple, tan, white, green, & black w/ white stripe. they went to the ECU so i'm thinking they were just for data.

[myzterray]

yeah, i have about 6 wires that i cut that go into the grommet, yellow, purple, tan, white, green, & black w/ white stripe. they went to the ECU so i'm thinking they were just for data.

oh ok cool. i didnt have that many. yellow white green black or something idk. im going to plug everything up tomorrow and cross my fingers lol

[RPM Graphics]

firewall is done.

[RS/SS 4.8]

Ur trucks gonna be sick when its done. Ive always liked the caddy front ends on those. Keep it up

[LS1GMCTruck]

In the same GM Service Manuel, they show what those wires go to, coming out of the passenger side firewall.

[RPM Graphics]

yeah, i need to find one of the these Service Manuals.

[RPM Graphics]

[RPM Graphics]

it's in!!!!! i used the middle position on the adapter plates. i don't think the headers would have fit if i would have went 1" forward or 1" back. i'm using the Camaro trans & had to move my trans cross member back about an inch, fortunately the holes where already there.
now it's time to start the wiring & plumbing.

[DjGreggieP]

Looking Good!!