Look at turn key engine supply. Their water pump fitting comes out the front and has a cap of some sort where the pipe is. Don't know how they do it but it might give you an idea.
Look at turn key engine supply. Their water pump fitting comes out the front and has a cap of some sort where the pipe is. Don't know how they do it but it might give you an idea.
you can use an fbody waterpump with spacers between it and the block to get the alignment back to the pullies.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
you can heat it up and turn it, it should seal up just fine. if not rub a little silicone around it and slide it back in, BAM!
PERFORMANCE-TUNING-FABRICATION12617 FM 917Alvarado, TX 76009
No leaks on mine, no sealer
yea i have had good luck with some and no luck on others.Originally Posted by slow600
PERFORMANCE-TUNING-FABRICATION12617 FM 917Alvarado, TX 76009
Posting Permissions
Reply With Quote
