IS that the one going to your heater core.
IS that the one going to your heater core.
THEY CALL ME G.
AZRAEL
2017 RZR 1000 2 SEATER
2023 RZR 1000 XP 4
2008 LTZ DURAMAX 3500
2023 300S 5.7
2023 BUICK ENCORE[/B]
The difference between winning and losing, is having a 2nd stage.
No...it goes to the radiator (pipe in picture)
Last edited by deelli; 12-28-2011 at 08:56 PM.
Im pretty sure they are pressed in, why do you want to do to it and why?
Using the engine in a 63 Nova and want to route the radiator hose towards the drivers side and point downwardOriginally Posted by Jess
If nothing else, maybe cut and bead roll the existing pipe the use a mandrel bent pipe connect with hose and clamps. Unless you're going for the clean look of a well made turnaround pipe
Look at turn key engine supply. Their water pump fitting comes out the front and has a cap of some sort where the pipe is. Don't know how they do it but it might give you an idea.
you can heat it up and turn it, it should seal up just fine. if not rub a little silicone around it and slide it back in, BAM!
PERFORMANCE-TUNING-FABRICATION12617 FM 917Alvarado, TX 76009
i turned mine to clear a re-located a/c compressor. i just used a propane torch to heat the aluminum. it got very loose, would have pulled out easily. id imagine you could heat back up to put back in. you can barely see it in this pic, its pointed straight forward now
020 (3).jpg
Posting Permissions
Reply With Quote
