Jetmech's Garage

[jetmech]

The only thing wrong with the hangers was the ride height. I currently have a DJM 2/4 drop which uses lower A-arms up front and shackles/hangers in the rear. When I pulled off the DJM hanger and monuted the caltracs hanger, the bolt hole was about an inch lower - which would have raised the rear of the truck about an inch. I found some belltech hangers that will work with the caltracs. I might have to modify them a bit but they'll work. I'm thinking about doing a write-up when I go to install the caltracs with the new hangers.....

[George C]

i also have the DJM 4" drop and just got my caltracs today. I was going to make my own hanger but what are you doing with those calvert hangers then?

The only thing wrong with the hangers was the ride height. I currently have a DJM 2/4 drop which uses lower A-arms up front and shackles/hangers in the rear. When I pulled off the DJM hanger and monuted the caltracs hanger, the bolt hole was about an inch lower - which would have raised the rear of the truck about an inch. I found some belltech hangers that will work with the caltracs. I might have to modify them a bit bit they'll work. I'm thinking about doing a write-up when I go to install the caltracs with the new hangers.....

[jetmech]

I already returned the caltracs hangers. From what I have researched tho, these are the appropriate hangers for a 2/4 drop when using caltracs

http://www.summitracing.com/parts/BEL-6512/

[Botlfed]

thats what clavert ended up doing on mine, sent me belltech, i dont know why i didnt rwemember that.

[jetmech]

The caltracs have been installed. I'll post up some pics when I get a chance........

[RS/SS 4.8]

This is one of my favorite nbs ecsb trucks on here. Keep it up

[Mang213]

Pics or it didn't happen. You know the rules around here, B