Aluminum will likely melt.
Aluminum will likely melt.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
He wants the plug on the intake Greg. He has my old LT's.
2013 CC 5.3
81 C10 LS1 project
LOL since It melts at 1220*Originally Posted by RedHeartbeat
You can use a freezeplug for the EGR port on the intake
95 C1500 LM7, built 4L60e, Circle D 3200, LT's, Nelson tune, open differential, 3.42, and LS1 e-fans. Tractionless
I hear that all the time, but I just dont trust it. Im sure its plenty safe, but I am very untrusting.
T-RAV99 GMC | 5.3 | Skinny White Guy Tuned
Duct tape!
2006 SilveradoLittle Black Bitch
You rang?
cjriojas:if you're weather man is a 5 gallon bucket, YOUUUUUUUUUUU might be a redneck
danger_ranger83: I see now why it cost so much to get a harness made... FML
2boostedSilverado: I like Casey's rear end, I want to chat with him about it
travis you remember how much boost mitch ran on the dyno in texass? he had a rubber plug in his intake then. also you better have some thick alum for your block off. we made one for the denali that was aluminum and it always leaked. i found a piece of steel and made one for my truck with no issues yet.
rubber plug and steel block off is the way to go imho
its just a turbo 5.3 that a couple of kids threw together
01 silverado
09 cobalt ss
ive been using one for about a year and a half with no problems yet.
00 silverado
www.quickstreettrucks.com
Posting Permissions
Reply With Quote
