I actually did figure this out. Well sort of. I had to plug back in the stock tbi harness and run the 1st (top left-facing the engine and firewall) red wire constant to the battery. Then i got it cranking. I figure this was about right. Had to get power from the truck somehow. I did get cranking but no fire. So i took the pink wire on the factory tbi harness and also ran it to the battery. (for some reason the truck wouldnt start without it hooked to 12 volts. The "switched igniton wire" i tried running it to the igntion switch but for some reason the computer will not get power unless i hook up that wire to the "IGN" slot on the under dash fuse box. But will stay on constant. I know that aint the right way to hook it up.. also im not getting any power at all to my "fuel pump relay or fuel pump wire on the harness. Any sugguestions?