Hooking up OBS A/C to LS Style Sanden Compressor

[Kros383SS]

Now that my eng/trans is installed and running great, im focusing my attention on putting A/C back on my truck. Damn Houston heat is terrible!!!
All I have left from the OBS A/C is the lines.
I would need Evap core, Accumulator, Condensor, and I want to use the LS Sanden compressor.
I know about having to cut the frame for the compressor, my only problem is adapting the old A/C parts to the new compressor.

Hopefully someone has done this and point me in the right direction.

Thanks,
Richard

[RedHeartbeat]

Put the factory compressor back in the truck on the passenger top right using one of the custom brackets. I have the sanden on mine and it keeps freezing up inside the cab and I have no air flow then. When it happens I have to shut off the compressor and leave the fan on high to thaw it out, once it starts blowing warm air I can turn the compressor back on. May be a different issue but it's a PITA. This was on my 93.

[Kros383SS]

Put the factory compressor back in the truck on the passenger top right using one of the custom brackets. I have the sanden on mine and it keeps freezing up inside the cab and I have no air flow then. When it happens I have to shut off the compressor and leave the fan on high to thaw it out, once it starts blowing warm air I can turn the compressor back on. May be a different issue but it's a PITA. This was on my 93.

Sounds like it wasnt cycling at all.

Hmmm....I'll look into using the original comp. where would I find a custom bracket??
I'll probaly look at doing it both ways and seeing what would be a better route to take. And $$$ is always an issue.

I remember seeing a post where someone used a older camaro bracket, but Ive searched and searched with no luck

[Bluetruck96]

Current and kwik performance sell the same kit. as far as making your own bracket malibu racing forums had a write up about it. im at work so the computers are slow i cant post the link just google it.

[Kros383SS]

Current and kwik performance sell the same kit. as far as making your own bracket malibu racing forums had a write up about it. im at work so the computers are slow i cant post the link just google it.

I guess I suck at doing a search cause I can not find any info.

[Chevy-Art]

http://www.kwikperf.com/lsx_ac.html

[Chevy-Art]

http://www.ls1truck.com/forums/lsx-t...c-bracket.html

[beater6.0]

i notched my frame and used the ls ac compressor. and it is a tight fit. but i wanted to try and make it look factory. it was a pain. and even mine tends to freeze up on long road trips

[Chevy-Art]

And another one.
http://www.ls1truck.com/forums/lsx-t...-solution.html

[RPM Graphics]

i've been looking into the Kwik once i get my swap done. i also found this one on ebay.
http://cgi.ebay.com/ebaymotors/LS1-L...ht_1548wt_1165