Trick performance products turbo kit.
Turbonetics turbo 76mm with .96 ar this is the ball bearing turbo.
5lb and 7.5lb springs.
Coated hot pipes.
4.5" thick intercooler
Setup for maf less system /Speed density Running to a 92mm throttle body. It can be easily be modified to a 78mm throttle body. I think a different rubber coupler is all you would need.
You will need a few minor things.
A fitting for the oil return and a few water hoses. You have to splice into your heater hoses. You might need the fitting for the oil output on the engine. The 2500hd trucks have an oil cooler output. You can buy that piece for the oiling of the turbo. I think it is less than $40.00 I used a lingenfelter unit that allowed me to install an oil cooler that is not going with the system.
This kit will work for 4wd or 2wd trucks.
My price is $3000.00 + $100 for shipping anywhere in the lower 48.
I would be willing to meet some one some where reasonably close to me. I am 1 hour south of Atlanta. I would consider trades of a Daily driver type vehicle. Preferably one of equal value. I could be persuaded to add a little cash for the right vehicle. Thanks for looking.
Turbo Blanket goes with the system. I think I paid a couple hundred bucks for the blanket.
Cooler is a tad dirty. Never had any meth in it.
Installation is really easy. Only hard part was drilling the oil pan and putting in the return. That was really not that hard either.
4.5" thick. No the dollar does not go with it.
The coating seems to have flaked in a few places but overall is in good shape.
Pic of where the oil return was plumbed.
The wrap that is on the down pipe is not in the best shape. I would rewrap it.
![]()