Thanks for the quick responce, I unplugged the MAF, at first it didn't want to idle, after a few restarts it I let it idle, one thing it did fix was the hesitation when I stabbed the gas for a sec, it went away, I then turned it back off, plugged in the MAF, and the hesitation was back. Do you also think that the stock MAF is a big restriction with all the mods I have listed?Originally Posted by RedHeartbeat
The stock MAF is fine. It's probably either dirty or bad. See if you can get another one to try out of a different truck. Also, try cleaning that one carefully.
1969 Chevy RCLB C10 350/TH400 SOLD
2007 Chevy RCSB 4.8 4x4 LS SOLD
2008 Chevy RCSB 5.3 4x4 LT SOLD
2010 Chevy CCSB 6.2 4x4 LT SOLD
2005 GMC CCLB DRW 6.6 Duramax 4x4 191,000 and counting
2013 FORD CCSB F350 6.7 Powerstroke 4x4
Ok, we will clean it first and see how that works, thanks for the help guys, I will report back, and if anyone else has suggestions let me know, thanks a bunch!
One weird thing is though it never did this with the 5.3, and it's the same MAF from the 5.3. But the MAF did sit around for quite a bit before we got the motor in the truck so it could be quite dirty, guess we will find out tomorrow.
Since the hesitation went away when pulling disabling the maf, might be a dirty maf or the PCM thinks there is a lean condition or there is one.
A map sensor doesn't respond the same way to a vac leak.
What are the ltrims showing when the ma is plugged in?
Nelson Performance
FastestTruckList.com
NP on Facebook
Youtube Channel
'94 Chevy Truck: 8.9 et, 408 twins
You mean the fuel trims? This morning before we did any revisions with the base tune it was showing good, I think one bank was 0 and the other was -3 on the Verus. Also when I sent Vince the first data log he thought the fuel trims looked good, but the truck does act like it is running lean.
I should also say that once the truck is driving it is smooth as silk, drives very nice..
Posting Permissions
Reply With Quote
