is something wrong with my motor mount adaptors? got bored and mounted them and noticed mine fit differently than all the examples ive seen online. the pointed part on mine is on the bottom, cannot switch sides or they hit the mounting bracket directly above. what gives? (ignore the bit broke off in the allen bolt)
001.JPG
LOL, it's upside down.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
soooo.... pointed part towards the back? i thought i read it goes towards the front.
Pointed end goes up and toward the front of the engine.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
hmm, the pointed end cannot go up or it hits a mounting bracket on the block. its obvious which side faces out due the bolt hole recesses. ill take em off and try to figure it out.
shorten the bracket
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
yup, gonna hav to trim both corners down. can anyone verify these are the correct -1 plates i should be using
they are on the wrong side of the block. the 2 bolt holes go
at the top of the motor not the bottom.
2008 GMC CCSB 6.2/6L80e swap
Gen IV 5.3/60e swap 1994 ecsb W/T
so did you get the plates to work or not?
2008 GMC CCSB 6.2/6L80e swap
Gen IV 5.3/60e swap 1994 ecsb W/T
had to cut both top corners off, appears to be ok. ill find out for sure when i put the motor in.
Posting Permissions
Reply With Quote