86 Silv... I'm curious to see how that sits b/t the rails. AS I stated in the other thread, there seems to be plenty of room for the LS-based setups to fit in our style trucks. My question is how much notching, if needed, will need to be done. For my 5.3L's compressor, the hookups (hose connections) look to be the exact same connections from the OBS comp to the NBS comp. I haven't evacuated my old setup yet to pull the lines off to test fit, but eyeballing it makes this seem somewhat plug and play. Now, I'm sure I'll have to notch the frame a bit to allow the neck of the angled connector room to move with motor.

Just curious...