You can put the chain on the sprocket to help take up some of the gap. Zip tie the slack chain to itself close to the sprocket to help hold it on.
You can put the chain on the sprocket to help take up some of the gap. Zip tie the slack chain to itself close to the sprocket to help hold it on.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Just use the same 3 jaw puller that you would pull the harmonic balancer off with..
Tried that, it wouldn't reachOriginally Posted by DBRODS
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
autozone/advance should have two different 3 jaw pullers. One is a 1-2 ton and is only like 6 inches tall. The other is a 5 ton and is about 10 inches. I'm assuming ONE of them would work.
blown transmissions are about as useful as 97% of the guys on this forum
I have the bigger 3 jaw puller, works like a champ..
If youve got an air chisel it will vibrate it right off no problem, takes about 3 seconds.
2007 CCSB Z71 VortecMax: Stock!
Just like a fan clutch nut...LOL
And can I rent that puller???
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Posting Permissions
Reply With Quote
