the harmonic balancer? I go to Autozone and rent their Chrysler balancer puller, put a short 3/8" socket extension inside the bolt hole and then use a pusher rod inside the square drive of the socket to make the pusher long enough. Comes right off with no issues and then I return the puller and get my deposit cash back.
I think the pn is 27139, OEM brand.
Last edited by RedHeartbeat; 02-08-2011 at 08:48 PM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
The sprocket for the timing chain? Puller or heat it with a torch and beat it off with a hammer...(not suggested)
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
Ya, the sprocket for the timing chain. I'm trying to find an auto parts store that rents a puller but so far I've had no luck.
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Posting Permissions
Reply With Quote
