+ Reply to Thread
Results 1 to 5 of 5

Thread: 10 bolt - 4:56's, trutrac, powdercoated housing....

Hybrid View

  1. #1

    10 bolt - 4:56's, trutrac, powdercoated housing....

    10 bolt Rear axle that fits 99-06 Gm full-size trucks.

    I had this in my 01 silverado for about 700 miles, motor went, then truck turned into a snowball project but anyway....

    Has Detroit tru-trac, motive gear 4:56's , all new Timken bearings including axle ends and seals, 1350 Universal joint yoke, Moser Aluminum girdle/cover, Axle tubes fully welded to housing and powder coated black. Also comes with a new set of reman calipers with brackets. It does not have caliper mounting brackets or emergency brake hardware because i had to use it on my 14 bolt.

    I have the manual for the trutrac, just a couple pages to tell how the axle retainer goes in and what lube to use. It reccommends to use regular gear oil and not synthetic which was good - -a lot cheaper so i figured I would just change the oil a lot.

    also a page for the cover on how to torque the girdle bolts to the carrier caps. The gasket on the rear end I always use a little bit of grease on to keep it from sticking and kept it reusable.






    I will not ship this but would be willing to meet at a reasonable distance or even further for some extra $

    any questions post or pm me

    $900 firm

  2. #2
    Join Date
    Nov 2008
    Location
    Paris, Texas
    Posts
    1,732
    located where?

  3. #3
    sorry I forgot Pittsburgh, PA

  4. #4
    Join Date
    Jul 2008
    Location
    Racoon Twp., PA
    Posts
    1,572
    Good deal from a knowledgable person. Chris does all my gear setups.
    2013 CC 5.3
    81 C10 LS1 project

  5. #5
    bump

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts