5.3 into a 1990 OBS with a 5 speed

[Wagonbacker9]

I have found a flywheel for the 4.8l truck. Its only $60 at oriely's
I think that is the way im going to go due to cost

Thanks for the info

I'm putting together plans for a 5.3 swap, and am toying with a manual trans. Whats your part number and did it work?

[99kon]

Update
Going with a 6.0 not the 5.3
Hopefully doing the swap here in the next couple of weeks.

I'm putting together plans for a 5.3 swap, and am toying with a manual trans. Whats your part number and did it work?

I got all this for the swap to work with my 5 speed
P/N
Flywheel Oreilys $60 NFW1050
Pilot Bearing Napa $20 6302-VSP43
Release Bearing Ebay $20 1377C
Clucth Stock
Pressure Plate Stock

[nels450]

hey, just reading your guys' threads and was wondering if all this would apply for the swap i am working on. putting a 5.3 out of a 2000 into a 98 w/t that had a 4.3 with a 5 speed. thanks and sorry for jacking the thread as well

[91blkstpsd]

I just bought a 5.3L myself and planning on putting into my 93 with 5 speed as well. Im gathering swap parts right now but hope to do the swap here in about a month or so. Good luck with your and look forward to seeing some more progress!

[99kon]

I did this 2 weekends ago. Was waiting to sell the motor and just sold it yesterday for a little extra cash.
Motor may be going in this saturday depending on work!!!!

[lechez71]

cool keep us updated

[99kon]

Well guys its been a while.






After this my back went to s**t and i had to have back surgery. I bought a TBSS

Modded her quite a bit but i had my brother to help me work on her
Anyway
I went back to my dads house 2 weekends ago and started working on her again. I finished installing the Hyperflex kit including the body mounts, so now every single rubber bushing is gone!
My plans changed and now I'm going with a carbed set up.
Here is a pic of how she looked when i left my dads house.

[99kon]

hey, just reading your guys' threads and was wondering if all this would apply for the swap i am working on. putting a 5.3 out of a 2000 into a 98 w/t that had a 4.3 with a 5 speed. thanks and sorry for jacking the thread as well

Im sure its the same thing as far as fuel lines harness PCM etc...
The flywheel will probably also apply.