So the answer to this is prolly obvious and I just have failed to notice but where can I find pistons and rods for a 6.0? I'm gonna have to have it bored 30 over and it already needs three pistons and a rod. (dropped a valve) Pretty much I'm looking for a fairly cheap stock or close to stock setup for the bottom end. All help is greatly appreciated.
Always buying things I dont need to impress people I dont know
You will need a full set of custom pistons if you're having it bored 30 over. Stock pistons wont fit anymore. I believe Eagle makes the cheapest pistons you'd need.Originally Posted by Slammed96
So the answer to this is prolly obvious and I just have failed to notice but where can I find pistons and rods for a 6.0? I'm gonna have to have it bored 30 over and it already needs three pistons and a rod. (dropped a valve) Pretty much I'm looking for a fairly cheap stock or close to stock setup for the bottom end. All help is greatly appreciated.
I would get a good set of pistons, a good set of rods, and use your stock crank if I were you.
1969 Chevy RCLB C10 350/TH400 SOLD
2007 Chevy RCSB 4.8 4x4 LS SOLD
2008 Chevy RCSB 5.3 4x4 LT SOLD
2010 Chevy CCSB 6.2 4x4 LT SOLD
2005 GMC CCLB DRW 6.6 Duramax 4x4 191,000 and counting
2013 FORD CCSB F350 6.7 Powerstroke 4x4
eagle doesnt make pistons...?
01 Silverado
speed-pro and master engine products, IIRC. (enginetech.com)
Last edited by RedHeartbeat; 11-14-2010 at 10:35 PM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
I was thinking crank. Weisco makes pistons.
1969 Chevy RCLB C10 350/TH400 SOLD
2007 Chevy RCSB 4.8 4x4 LS SOLD
2008 Chevy RCSB 5.3 4x4 LT SOLD
2010 Chevy CCSB 6.2 4x4 LT SOLD
2005 GMC CCLB DRW 6.6 Duramax 4x4 191,000 and counting
2013 FORD CCSB F350 6.7 Powerstroke 4x4
Ill def be lookin into all of them...hopefully I can get this thing done with at least a semblance of a budget
thanks again for the help
Posting Permissions
Reply With Quote