well... then you'll want a higher stall to build some boost when you launch
well... then you'll want a higher stall to build some boost when you launch
00 FRC - just top end, exhaust, and a hot-air intake
99 Sierra - 5.3 / 5spd
↓ click the pic for the build ↓
Well I'm at a stop for my engine swap. 3 weeks ago, I gave my wiring harness to a local car electrical shop after they told me that the splice and repair would take just over a week. That was 3 weeks ago. When I call I get the owner who says he is going to call me back but he never does. I left him a nasty message last night and he called my wife this morning saying that she can pick up the harness after 2pm. He calls her and asks for a delay. My wife, digs her teeth in and he now says that he's going to drop it off at our house tonight, again after a few hours past, my wife calls and he says he just around the corner. That was 3 hours ago. My guess is the for what ever reason he doesn't have the harness. I'm not sure what my legal options are but I now have to find a full working engine wiring harness. WTF......
****Update****
The shop owner just left my house (10pm). The harness he had wasn't mine. I had every connection taped with blue & white tape stating location and purpose of plug. Not one piece of tape was on there. The 2 big connections for the PCM where wrong. I have a blue and red and his harness was blue and green. It also had a DBW connector and I have a 02 5.3 that has a cable throttle. I'm beside myself...... Needless to say he took the harness back with him to make the changes.
Last edited by carnell; 11-07-2010 at 01:07 AM.
File a complaint with the Better Business Bureau, for starters.
not if it has the long crankshaft on the rear of the engine. If the same amount of crank extends from the 6L as the 5.3L then it will swap straight out.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
i have an 04 with a 4.3l 5 speed
99-00 6.0's have the longer crank, and iron heads.
2006 SilveradoLittle Black Bitch
Can anyone verify that these are the part numbers for the frame brackets for the V8 motor mounts?
15871387 and 15113851
Ok guys I need some info I have a 2000 silverado with 4.3 and I want to swap to ls1 corvette engine on my truck,,, the engine come with trans already so I'm not worry about that,,my question is if I can use the same harness the come with the ls1 corvette or do I need a harness from a truck and what year.???
Thanks for the help.
You need a 99-02 truck harness
2006 SilveradoLittle Black Bitch
Posting Permissions
Reply With Quote
