fuel line quick disconnect - male end

[phantom405]

http://www.summitracing.com/parts/RUS-640940/

???

[oleshifty]

that has a AN fitting, then just get one that goes from AN to a barb, and run your high pressure hose as planned

[TXsilverado]

damn, so nobody makes on that is just barbed? is there a better way aka cheaper to do this lol. it seems like a waste to buy fittings to fit the fittings

[DBRODS]

Go to Oreillys or Parts house and get fuel injected hose. Take a razor blade and carefully cut the plastic line off the factory fittings. Push the Fuel injection hose on to the factory fittings and there you go. No clamp needed

[TXsilverado]

Go to Oreillys or Parts house and get fuel injected hose. Take a razor blade and carefully cut the plastic line off the factory fittings. Push the Fuel injection hose on to the factory fittings and there you go. No clamp needed

when you say cut the plastic line off of the fittings, do you just mean the quick disconnect part, or the actual plastic fuel line. i didnt look at everything close enough when i had the bed off. no clamp sounds scarry will it hurt anything if i do throw a clamp or 2 on there?